Grade 7

Curro 3D Print a pulley

A course to introduce learners to design in Tinkercad and progress to design and print a pulley in Fusion 360. 

Grade 7

Curro-Orlando Pilots - Educator

Drone Coding Course

This is the course for educators which includes lesson plans and memorandums. 

The Orlando Pilots 10 week course provides an introduction to Block Coding and Tello drones. It includes lessons and practical activities using Block Coding, which leads up to a challenge for learners to code a mission to inspect the Orlando Pilot's mission, using 3D coordinates. 

Grade 7

Curro-Orlando Pilots

Drone Coding Course

This interactive course is for learners. 

This 10 week course provides an introduction to Block Coding and Tello drones. It includes lessons and practical activities using Block Coding, which leads up to a challenge for learners to code a mission to inspect the Orlando Pilot's mission, using 3D coordinates. 

Grade 7

Curro (i)RL Relocating Cera

Interactive STEAM PBL to relocate a rhino using drone technology. 

Within this course, you can collaborate with all STEAM educators to form a termly project around saving rhinos, while aligning to the CAPS curriculum. 

Grade 7

Curro Introduction to HTML

This course includes the basics of HTML coding. The course includes guided HTML coding activities. 

Grade 7

Curro-Drone Aptitude

This course provides a general introduction to recreational drone flying. Learners can receive a certificate for completing this course.  

Grade 7

Curro Indoor Flying Course

The Inspire Indoor flying course teaches you how to configure your Tello drone and fly it!